|
By-Pass Oil Filters
Engine wear is caused by dirt particles larger than 5 microns. The AMSOIL By-Pass Oil Filter removes particles as small as 1/10 of a micron, virtually eliminating engine wear. AMSOIL By-Pass Oil Filters filter all the oil in a six-quart system in about five minutes at an average engine speed equivalent to 45 mph. |
(some mechanical ability required for installation)
|
|
"When we took this Chevrolet 396 engine apart (using AMSOIL Synthetic 10W-40, Reusable Air Filter and By-Pass Oil Filter), it was in the best condition of any engine I have ever seen. It looked like it had about 80,000 miles on it instead of over 535,000. The bearings were not even worn to the brass and the rings were not worn out. It was clean inside, no sludge or carbon at all."
K.A., Liberal, Kansas |
Typical By-Pass Installations.
|
 |
|
Image not shown |
Image not shown |
Image not shown |
Frame Mount 1
Click for larger image |
Frame Mount 2
Click for larger image |
Under Hood Mount 1
Click for larger image |
PRODUCT DESCRIPTION
The AMSOIL By-Pass Oil Filter provides the best possible filtration protection against wear, oil degradation, rust and corrosion. Working in conjunction with the engines full-flow oil filter, the AMSOIL By-Pass Filter operates by filtering oil on a "partial-flow" basis. It draws approximately ten percent of the oil at any one time and traps the extremely small, wear-causing contaminants and water that full-flow filters cant remove. The AMSOIL By-Pass Filter typically filters all the oil in the system several times an hour, so the engine continuously receives analytically clean oil.
 |
Typical Installation Diagram for
BMK-11 and BMK-12 Kits |
Unknown Gem Type: tlx.tlx.tellyourfriends |
